Sure-heat SGR30M Uživatelský manuál

USE AND CARE MANUAL For Model SGR30MLP STOP! Missing A Part? Do Not Return Product! The store where you made the purchase does not stock pa

LP Gas Cylinder Installation 1. The gas supply must be turned off at the LP gas supply cylinder when this gas grill is not in use. 2. Storage of thi

Pre Operation Leak Testing GENERAL INFORMATION Although all gas connections on the grill are leak tested prior to shipment, a complete gas tightness

Lighting the Grill BEFORE LIGHTING Important! Before Lighting: • Check the gas supply line for cuts, wear or abrasion. • Always keep your face

Using the Grill and Side Burner GRILL LOCATION Do not use the grill in garages, breezeways, sheds or any enclosed area. Never operate the grill in

Using the Rotisserie Burner The grill rotisserie system is designed to cook items from the back using infrared heat. The rotisserie burner is an infr

Rotisserie Lighting/ Care and Maintenance ROTISSERIE LIGHTING Open the lid. Push and turn the control knob for the rotisserie count-er clockwise to

Troubleshooting Your Grill GENERAL TROUBLE SHOOTING You should inspect the burners at least once a year or immediately if any of the following conditi

Troubleshooting Your Grill Grill will not light with a match or low heat with dial set to "High" position. Note: PreHeating time can take

Notes

Warranty LIMITED WARRANTY Because of continuing product improvement these specifications are subject to change without notice. If you have oth

General Safety Instructions IMPORTANT SAFETY INFORMATION Read this manual carefully before using your grill to reduce the risk of fire, burn hazard

General Safety Instructions TESTED IN ACCORDANCE WITH ANSI Z21.58b-2005/CSA 1.6b-M02 STANDARD FOR OUTDOOR COOKING GAS APPLIANCES. THIS GRILL IS FOR

Grill Features 1. Roll top grill hood 9. Hood Handle 2. Rear Infrared Burner 10. Warming shelf 3. Rotisserie M

Grill Assembly IMPORTANT: Remove all protective film from stainless steel parts to assembly/use. This film is installed at the factory to prevent da

Grill Assembly 4. Install one self tapping screw into the bottom front hole of the shelf to lock shelf in place. (See Fig. 7) 5. Remove the nut from

Grill Assembly IGNITER ASSEMBLY 1. The battery, igniter cap must be installed before using. 2. Slide the threaded part of the igniter through th

Grill Assembly INTERIOR PARTS ASSEMBLY 1. Insert the top row of flavor grids into the cutouts with triangle ridges facing up. (See Fig. 19) 2.

Gas Requirements L.P. GAS INSTALLATIONSonoma Gas Grills are set to operate with L.P. gas and come with a high capacity hose and regulator assembly.